About Sikkens Rubbol WF 3310 Water based one pot two coat finish for exterior timber cladding.
Sikkens Rubbol WF 3310 is a midcoat and topcoat and dries to a durable, hard wearing Semi-Gloss or Semi-Matt finish
Unlimited colour possibilities, they can be tinted to any opaque colour from any colour card.
Excellent protection in all weather conditions including heat, rain, hail, extreme sun, frost and snow.
It's elastic formula moves with the wood as it expands and shrinks during fluctuations in moisture and temperature.
It is extremely moisture vapour permeable, keeping a good moisture balance to prevent the film from blistering or cracking.
Rubbol WF 3310 is applied by vacuum coater, spray or by brush application and can be used on both interior and exterior wood.
Perfect for extending the durability of wooden windows,doors and timber cladding.
Wet film thickness, 2 x 150 μm or 1 x 150 up to maximum of 300 μm
Supplied ready for use, do not dilute
We recommend applying two coats of each colour shade.
Approximate coverage rate
150 - 300 ml/m², depending on applied wet film thickness per coat without overspray.
Drying times at 23°C / 50% RH.
Dust dry approx. 60 minutes
Sandable approx. 3 - 4 hours
Recoatable approx. 4 - 6 hours
The drying process of the coating depends on the applied film thickness and may be delayed when using timber with a high extractive contents or drying in
damp/cold conditions. During the drying process, always ensure for adequate temperature and ventilation. If the drying conditions are not met, damages
within the coating cannot be excluded.
Clean with water immediately after use Sikkens ST 830 Cleaning Solution.