About Rust-Oleum Epoxy Rust Primer 9169
Rust-Oleum High-Performance Epoxy System Rust Primer 9169 is based on two-component, solvent-based epoxy resins and rust-inhibitive pigments.
It is formulated for application on manually prepared rusted steel surfaces and offers excellent protection against strong chemicals, acids, alkalis and solvents; frequent product spillage and regular chemical cleaning; high humidity and moisture conditions.
The lower cost alternative to blast cleaning.
- Apply directly to rust covered steel
- Excellent chemical resistance
- Over coat with High performance epoxy finishes
Surface Preparation
Remove grease, oil and all other surface contaminations with ND14 cleaner Degreaser or high pressure (steam) cleaning. Remove loose rust, mill scale and deteriorated coatings by hand or power tool cleaning. Sand previous coatings which are in good condition to remove gloss and to roughen the surface slightly check compatibility.
The surface must be clean and dry during application.
Application and Thinning
Brush: Up to 10 vol.%; RUST-OLEUM Thinner 160. Use natural bristles, longhair brushes.
Roller: Up to 10 vol.%; RUST-OLEUM Thinner 160. Use short/medium pile polyamide (perlon 8 - 12 mm) rollers.
Air-atomised spray: Up to 20 vol.%; RUST-OLEUM Thinner 160.Gravity cup and pressure cup. Tip size: 1.2 -2.2 mm. Atomising pressure: 2 - 4 bar.
Airless spray: Up to 10 vol.%; RUST-OLEUM Thinner 160.Pneumatic and electric airless equipment. Tip size: 0.013-0.018 inch.Fluid pressure: 125 - 200 bar. Avoid excessive film thickness.
