About EpoxyShield Ultra
EpoxyShield Ultra is a quick-drying single pack water-based floor coating for light to medium duty (normal foot traffic / limited vehicular traffic).
Good resistance to diesel, motor oil, coolant fluid, various household chemicals and most types of tyre.
It can be applied on concrete floors which are completely clean, dry and treated with EpoxyShield Sealer 5220.
- For light / medium traffic
- Waterborne, low VOC and low odour
- Easy to apply
- Touch Dry after just 2 hours
- Satin Matt finish
- Good resistance to car tyres and chemicals
Surface Preparation
Remove oil, grease and all other contaminants with ND14 Cleaner degreaser in combination with high pressure cleaning.
Allow new concrete to set for at least 30 days before applying a coating.
Remove loose and damaged concrete by sandblasting or etching with RUST-OLEUM Surfa-Etch 108 Solution.
Repair all holes and cracks.
Always pre-treat absorbent, porous surfaces with EpoxyShield Sealer 5220.
Roughen or blast well-sealed and smooth concrete and treat with Epoxyshield Sealer 5220 or apply a coat RUST-OLEUM 3333 Super Adhesion Primer.
Roughen still-intact floor coatings to ensure good adhesion.
Remove poorly adhering old coatings with wire brush and sandpaper.
During application the surface must be clean and dry.
Application and Thinning
Brush: Product is ready for use, dilution is not necessary.
Roller: Product is ready for use, dilution is not necessary. Use a nylon paint roller (12 mm).
In case of roller application it can be necessary to apply 2 coats in order to achieve the correct film thickness.
Do not apply to smooth and completely sealed concrete or concrete containing a curing compound. Such floors will prevent a good adhesion.
EpoxyShield 5200 ULTRA can also be applied on old, good adhering coatings.
