Teknos Topaz Water-Borne Wooden Floor and Parquet Lacquer

Brand:
Reference:
TTOPAZ

Teknos Topaz Wooden floor and Parquet Lacquer is a single pack, easy to apply, very tough finish for most interior domestic and commercial wooden floors.

Also ideal for refreshing previously sealed wooden floors.

  • Quick Drying
  • 2 hour recoat
  • M1 Classification for low odour and particulates
  • Excellent scratch and chemical resistance
  • Low Odour
  • Non Yellowing
  • Semi-Gloss and Semi-Matt finish
Limited special offer
£80.81 £56.57 (excl VAT) 30%
£56.57 £80.81
Reduced price-30%
Size
  • 5L
Finish
  • Semi-Matt
  • Semi-Gloss
Close
Description

About Teknos Topaz Single Pack Water-Borne Wooden Floor and Parquet Lacquer

Teknos Topaz Wooden floor and Parquet Lacquer is a very tough, easy to apply, water-borne finish for interior commercial and domestic wooden floors.

It is rapid drying, excellent scratch, chemical and black heel mark resistance, while being low odour and non-yellowing.

Surface Preparation

Teknos Topaz Wooden Floor and Parquet Lacquer should only be applied to clean, dry substrates free from dust, dirt, wax, maintenance product residue, grease or anything that will inhibit good adhesion.

Oily hardwoods and knots should be cleaned with a ‘sharp’ solvent.

The use of knotting solution under Topaz Wooden floor and Parquet Lacquer is not recommended.

As it provides a transparent finish, any marks, blemishes or stains will be apparent after treatment.

Do not use wire wool for surface preparation.

Untreated Floors

  • Punch in all nails and fill holes with an appropriate shade of Prestonnet Wood filler.
  • Thoroughly sand the floor with a machine sander in the direction of the grain, back to clean, and bright wood.
  • Wood block floors should be sanded twice in two directions at right angles to each other.
  • Avoid inhaling dust by wearing a suitable facemask.
  • 120 grade sandpaper should be used for final sanding. Round off any sharp edges.
  • Repair any surface defects with Wood Filler and sand smooth.
  • Allow dust to settle and remove by vacuuming.
  • Wipe over with a ‘sharp’ solvent and allow to dry thoroughly.
  • Prime with Teknos Forme Wood Floor and Parquet Primer and allow to dry.
  • Apply 2-3 coats of Teknos Topaz by brush or roller

Previously Varnished Floors

  • Ensure that the surface is clean and free from wax, polish or other contaminants.
  • Thoroughly abrade to form a key using 120 grade sandpaper or wet and dry paper.
  • If the floor has been oiled or coated with a polyurethane or solvent based floor lacquer the floor must be sanded to new fresh timber 
  • Avoid inhaling dust by wearing a suitable facemask.
  • Remove dust by vacuuming and wipe over with a ’sharp’ solvent and allow to dry.
  • Varnish in poor condition should be completely removed.
  • Test a small area first for coating adhesion and/or compatibility prior to treating the whole floor.
  • Apply 1-2 coats of Teknos Topaz

Application and Thinning

Use a lamb’s wool or synthetic applicator or roller.

Do not thin.

Avoid over rigorous application.

To ensure good coverage use the applicator to spread the seal evenly and smoothly over the floor, taking care to avoid ponding or excessively thick areas of lacquer.

If required the lacquer may be lightly sanded between coats.

Prior to application of the final coat, lightly de-nib with an appropriate grade abrasive paper, remove dust by vacuuming.

Always check adhesion prior to application by applying to a small test area.

After Care

The newly finished floor reaches its final hardness and washability within 2 weeks.

Rough handling and washing is to be avoided during this period.

Stained surfaces can be cleaned with a moist cleaning cloth or mop - Use a neutral detergent.

Very dirty surfaces can later be cleaned with a slightly alkaline universal washing detergent.

Features
TTOPAZ
FAQS

Be the first to ask a question about this product!


Question about the product

* Required fields
Send Question
All Colour Charts
Related products
Teknos Forme Wooden Floor and Parquet Primer Teknos Forme Wooden Floor and Parquet Primer
Limited special offer
Interior Floors
£67.30 £47.11 (excl VAT) 30%
£47.11 £67.30
Reduced price-30%
Teknos Forme Wooden Floor and Parquet Primer is a water-borne primer specifically formulated to prime and seal wooden flooring prior to overcoating with Teknos Topaz and Teknos Opal wooden floor lacquers. Quick...
Recently Viewed

Menu

Settings

Need help? Call 01793 511537