Rust-Oleum 5090 Anti-Condensation Coating

Reference:
R5090

For ceilings and the upper parts of walls to prevent dripping from condensation. Can be applied to slightly damp surfaces and is recoatable after just 5 hours.

Colour: Off White

£103.29 (excl VAT)
£123.95 (incl VAT)
£103.29 (tax excl.)
Size
  • 5L
Close
Description

About Rust-Oleum 5090 Anti-Condensation Coating

Anti-Condensation Coating 5090 is a water-absorbing coating. It contains a non-leaching fungicide to prevent mould growth.

It is formulated for use on ceilings and the upper parts of walls to prevent condensation and dripping.

1 litre of this product will, after drying, absorb at least 400 grams of water.

Approvals: Mould Resistance by Itec. Absorption by Ceripec.

  • Water Based
  • Recoatable after 5 hours
  • Application to damp surfaces
  • Ideal for high humidity areas (breweries, washrooms, shower rooms and manufacturing plants)

Surface Preparation

New concrete or brick surfaces should cure and dry for at least 30 days prior to application of the coating.

Repair surface defects of (coated) concrete or brick surfaces.

Remove grease, oil and all other surface contaminations using ND14 Cleaner Degreaser or high pressure (steam) cleaning.

Scrape and wire brush carefully to remove deteriorated coatings.

Sand previous coatings which are in good condition to remove gloss and to roughen the surface to create a key.

The surface may be slightly damp during application.

Application and Thinning

Brush/Roller: Up to 5 vol. % water. Use a distemper brush and/or a medium pile, polyamide roller. For textured surfaces use a long pile roller.

Air-atomised spray: Not recommended.

Airless spray: If required up to 5 vol. % water. Pneumatic and electric airless equipment. Tip size: 0.018-0.024 inch (use reverse tips). Fluid pressure: 130 - 200 bar. Check wet film thickness, avoid excessive film thickness.

Features
R5090
Drying Time - Touch Dry
1hr
Drying Time - To Handle
2hrs
Drying Time - Recoat
5hrs
Drying Time - Full Cure
3 Days
Coverage (m2 / litre)
5.4
Application
Brush, Roller, Spray
Single / Two Pack
Single
Finish
Matt
Water Based
Yes
FAQS

questions scott sharp
Question: Can this be used on steel surfaces ?
Answer: 

Rust-Oleum Anti-Condensation Paint 5090 is formulated for application to walls and ceilings only.

To help with condensation on metal surfaces we would recommend an alternative product manufactured by the Finnish company Tikkurila and is called GrafoTherm.

This is a water-borne anti-condensation coating for steel roofing sheets, steel structures and other metal surfaces, where condensation and dripping-water problems occur.


Question about the product

* Required fields
Send Question
All Colour Charts
Recently Viewed

Menu

Settings

Need help? Call 01793 511537