Rust-Oleum Hard Hat Anti-Corrosion Primer 2169/2182 Aerosol
Hard Hat Aerosol Primer 2169 / 2182 provide quick drying, anti-rust protection.
Use for new and slightly rusted surfaces, it penetrates and eliminates moisture and air.
The products contain rust-inhibitive pigments and are lead and chromate free.
Ready to recoat within 1 hour or after 48 hours, to handle after 30 minutes.
Penetrates deeply into the surface and does not give rust a chance.
Grey for light coloured topcoats and Red for dark coloured topcoats.
About Rust-Oleum Hard Hat Anti-Corrision Primer 2169/2182 Aerosol
About Rust-Oleum Hard Hat Anti-Corrision Primer 2169/2182 Aerosol
For use on new, bare or slightly rusted steel surfaces.
Red Primer 2169 / Grey Primer 2182 are quick drying and intended to be applied on small areas or for touch-up.
Can be re-coated with Rust-Oleum Hard Hat Topcoats.
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
Sand intact coatings to roughen the surface slightly. The surface must be clean and dry during application.
Penetrates deep into the surface and does not give rust a chance to re appear
Lead and chromate free
Remove cover cap.
Shake vigorously for at least one minute after the rattle of mixing ball is heard.
Shake frequently during use.
Hold can approximately 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness.
After use turn can upside down and press spray button for 2 - 3 seconds to clean valve
For a brushable version, see CombiPrimer.
For further information refer to the Product Data Sheet and Material Safety Data Sheet.
- Drying Time - Touch Dry
- 15mins
- Drying Time - To Handle
- 30mins
- Drying Time - Recoat
- 45mins to 48hrs
- Drying Time - Full Cure
- 7 Days
- Coverage (m2 / litre)
- 3-4m2 per can
- Finish
- Matt
- Solvent Based
- Yes