About Rust-Oleum Hard Hat Fluorescent Finish

Rust-Oleum Hard Hat Aerosols Fluorescent Topcoats are formulated on a fast drying acrylic resin and special fluorescent pigments.

They are suitable for safety marking or signalling in light industrial, building and construction environments.

For best results in exterior application, over coat with Hard Hat 2500 Clear finish.

Surface Preparation

Remove dirt, grease, oil and all other surface contaminants by using ND14 Cleaner Degreaser.

Sand intact coatings to roughen the surface slightly.

The surface must be clean and dry during application.

Application and Thinning

Shake vigorously for at least one minute after the rattle of mixing ball is heard.

Shake frequently during use.

Hold can approx. 25 cm from surface.

Use back and forth motion keeping can parallel with surface.

Ensure that can is in motion when spray button is pressed to avoid runs and sags.

Apply several thin layers at a few minutes interval to achieve adequate coating thickness.

After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.