About Rust-Oleum Supergrip Anti-Slip Spray
Rust-Oleum Supergrip Anti-Slip 2400 is based on fast drying acrylic/alkyd resins and a special anti-slip additive.
It is suitable for application on metal, concrete, ceramic and wood surfaces or properly prepared painted substrates.
Steelwork should be primed with Primers 2169 or 2182.
- Suitable for metal, wood, concrete and tile floors.
- Very quick drying.
- For use on floors, steps handles and grips.
Surface Preparation
Remove dirt, grease, oil, loose rust and all other surface contaminants by using ND14 Cleaner Degreaser.
Sand intact coatings to provide a proper key for adhesion.
The surface must be clean and dry during application.
Application and Thinning
Shake vigorously for at least one minute after the rattle of mixing ball is heard.
Shake frequently during use.
Hold the can approx. 25 cm from surface.
Use back and forth motion keeping can parallel with surface.
Ensure that can is in motion when spray button is pressed to avoid runs and sags.
Apply several thin layers at a few minutes interval to achieve adequate coating thickness.
After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
Special note: Not for use in wet areas such as bathrooms and on substrates, which are regularly in contact with, water.
