£26.87 (incl VAT)
Tikkurila Unica Akva Lacquer
An extremely durable medium build waterborne semi-transparent wood finish for use on exterior wood.
Suitable for exterior smooth surfaces such as window frames doors and conservatory woodwork.
Not recommended for dense and hard wood species such as oak and teak.
Semi-Gloss Finish in an extensive range of semi-transparent shades
£26.87 (incl VAT)
About Tikkurila Unica Akva Lacquer
Tikkurila Unica Akva Lacquer is an extremely durable waterborne semi-transparent wood stain and finish for use on new or previously stained exterior wood.
Suitable for exterior smooth surfaces such as window frames doors and conservatory woodwork.
It forms a tough water repellent surface and protects the wood from weathering and retards the adverse effects of moisture and UV degradation.
Available in a wide range of semi-transparent colours,
Tikkurila Unica Akva enhances the natural beauty of wood.
Surface Preparation and Application.
Surfaces must be clean, dry, and free from grease, dirt, oil, wax, loose material and surface contamination. Use Tikkurila Mould Removal Solution and Cleaning Solution.
Fill cracks, joints, nail holes with a good quality wood filler.
Ensure that existing glossy, previously stained and filled surfaces are thoroughly sanded to ensure adequate penetration in to the surface of the wood.
Make sure that timber cladding, weather boarding and timber glazing beads, etc., are adequately fastened with non-corrosive fixings.
Good quality non-setting glazing compounds which form a protective skin should be used in accordance with manufacturer’s instructions.
Particular attention with regards to preparation should be given to wood such as Cedar, Douglas Fir, Mahogany and Idigbo, which contain oil and water-soluble tannin which
may impair the drying, hardening or adhesion and possible staining of surface coatings.
When coating new woodwork it is recommended that a priming coat of Valtti Base should be applied to all exterior wood which has not been pre-treated or vacuum impregnated with an approved wood preservative.
Apply liberally on end-grain.
Tikkurila Unica Akva is not recommended for use with silicone sealant or linseed oil putty.
Application and Thinning
Methods: brush or spray.
Conventional spray : use 1.4-1.8 nozzle, thin 5-15% by volume
For airless spray: use a 0.009” – 0.013” spray tip. Thin 0-5% by volume.
Note: Synthetic polyester and nylon paint brushes are best suited for the application of Tikkurila Unica Akva
All surfaces to be painted must be dry, the moisture content of the wood below 20%, the temperature of the air at least +50C, and the relative humidity of the air below 80%.