Top sellers

Ronseal Quick Cure Waterbased Floor Finish

New product

Ronseal Quick Cure Floor Seal is a quick drying and hard wearing polyurethane interior floor seal.

With excellent durability, and scratch and heel mark resistance.

Suitable for domestic and commercial interior flooring.

Water based formula is low odour and non-yellowing. 

Can be applied to most interior flooring materials. 

Matt, Satin, or Gloss Finish. 

More details

£77.42

- +

Brand: Ronseal

 
Product Info

Ronseal Quick Cure Floor Seal

Ronseal Quick Cure Floor Seal is recommended for use on most interior flooring materials, such as hardwood, strip block and mosaic flooring and softwood boarding, as well as cork, untempered hardboard, chipboard and wood composites. It may also be used on previously sealed wooden floors after suitable preparation.

100% cure in 12 hours
Quick Dry – 11/2 hour recoat
Excellent scratch and chemical resistance
Low Odour
Non Yellowing
Conforms to BS7044 (Part 4) 1991

Surface Preparation
Ronseal Quick Cure Floor Seal should only be applied to clean, dry substrates free from dust, dirt, wax, maintenance product residue, grease or anything that will inhibit good adhesion. Oily hardwoods and knots should be cleaned with a ‘sharp’ solvent. The use of knotting solution under Quick Cure Floor Seal is not recommended.
As Ronseal Quick Cure Floor Seal provides a transparent finish any marks, blemishes or stains will be apparent after treatment.
Do not use wire wool for surface preparation.

Untreated Floors
Punch in all nails and fill holes with an appropriate shade of Ronseal Multi-Purpose Wood filler. Thoroughly sand the floor with a machine sander in the direction of the grain, back to clean, and bright wood. Wood block floors should be sanded twice in two directions at right angles
to each other. Avoid inhaling dust by wearing a suitable facemask. 120 grade sandpaper should be used for final sanding. Round off any sharp edges. Repair any surface defects with Ronseal Multi-Purpose Wood Filler and sand smooth.
Allow dust to settle and remove by vacuuming. Wipe over with a ‘sharp’ solvent and allow to dry thoroughly.

Previously Varnished Floors
Ensure that the surface is clean and free from wax, polish or other contaminants. Thoroughly abrade to form a key using 120 grade sandpaper or wet and dry paper. Avoid inhaling dust by wearing a suitable facemask. Remove dust by vacuuming and
wipe over with a ’sharp’ solvent and allow to dry. Varnish in poor condition should be completely removed.
Test a small area first for coating adhesion and/or compatibility prior to treating the whole floor.

Application and Thinning
Use a lamb’s wool or synthetic applicator or roller.
Do not thin.
Avoid over rigorous application.
To ensure good coverage use the applicator to spread the seal evenly and smoothly over the floor, taking care to avoid ponding or excessively thick areas of seal. If required the seal may be lightly sanded between coats.
Prior to application of the final coat, lightly de-nib with an appropriate grade abrasive paper, remove dust by vacuuming.
Always check adhesion prior to application by applying to a small test area.
 

 
Technical Data
Coverage Smooth
Finish Matt, Satin, Gloss
Waterbased Yes
01.Drying Time (Touch Dry) 30 minutes
03.Drying Time (Recoat) 1.5 hours
04.Drying Time (Full cure) 12 hours
Smooth Coverage (m2 / litre) 10-12
Type Single Pack
Application Method Brush, Roller, Pad

Accessories

11 other products in the same category:

Menu

Top
Compare 0