Rust-Oleum Solvent Borne Floor Coating is a high quality, durable single pack coating for light to medium traffic areas.
It has a High Gloss finish that is easily cleaned. It can be applied on new and previously coated wooden floors that are completely clean and dry.
Single pack, solvent based
For foot traffic, interior and exterior
High Gloss finish that is easily cleaned
High film build in one coat
Touch dry after 6 hours
Easy to apply with brush and roller
Ensure that the surface is clean and free from wax, polish or other contaminants. Thoroughly abrade to form a key using 120 grade sandpaper or wet and dry paper. Remove dust by vacuuming and wipe over with a ’sharp’ solvent and allow to dry. Varnish in poor condition should be completely removed.
Test a small area first for coating adhesion and/or compatibility prior to treating the whole floor.
On porous timber floors thin the first coat with up to 10% thinners.
Application and Thinning
Brush: Sparingly, if required, with 10% special thinners 7301.
Roller: Sparingly, if required, with 10% special thinners 7301.
In case of roller application it can be necessary to apply 2 coats in order to obtain the recommended film thickness.
On oily or resinous timbers wipe the surface with a sharp solvent and allow to dry. Test a small patch for adhesion.