Current best sellers

Special Offers

Tikkurila Parquet Floor Lacquer

New product

A highly durable water-borne polyurethane-acrylate lacquer for coating interior sanded wooden surfaces. No need for a separate priming lacquer.

More details

We can tint this product to your exact specification from any colour chart or sample. Enter your chosen colour in the box below and click CONFIRM COLOUR before adding the product to your basket. Need help? Call us on 01793 511537

ENTER COLOUR CHOICE:

loader

£203.99

- +

 
Product Info

Water-borne polyurethane-acrylate lacquer for varnishing interior sanded wooden surfaces and is ideas for recoating and maintaining existing coated floors. No separate priming lacquer is required.
It is ideal for parquet and board floors and other interior wooden surfaces which are subject to heavy mechanical and chemical pressures.

Always ensure Parquet-Ace Floor Lacquer is suitable for the wooden surface by testing it on a small area before treating the whole surface.

Parquet-Ace lacquer is not suitable for diamond pine, smoked oak or stabilized brown beech surfaces.

Surface Preparation and Application
Sand parquet and board floors mechanically and fill holes over 0.5 mm wide with a putty made of wooden sanding dust and Parquet-Ace lacquer. Apply the putty to the whole floor with a stainless steel spatula with crossed strokes. Sand after approx. one hour in the direction of the grain.

Pour the lacquer on the floor and spread with a stainless steel trowel tightly in direction of the wood grain and texture. Allow to dry for approximately 1 hour and if needed sand to de nib the surface. Remove sanding dust carefully with a vacuum cleaner. Apply 1-2 steel trowel strokes with the Floor Lacquer. Allow the surface to dry 30-60 minutes between each layer.

Previously lacquered / painted parquet and wooden floors:
Clean the wooden floor from dirt, wax and grease. Sand down surfaces in poor condition to bare wood and apply lacquer like instructed above. Remove sanding dust carefully with a vacuum cleaner and wipe the surface with a damp, lint-free and clean cloth. Before lacquering, check the suitability of Parketti-Ässä on previously treated floors by lacquering a small test area. Apply one or two coats with a roller.

Uneven wooden floors:
Apply to uneven wooden floors by brush.
Apply a thin layer and allow to dry at least 1 hour. Continue few boards at a time following the wood grain.
Spread the lacquer evenly, avoid rubbing circular movements. Sand the surface and remove sanding dust carefully. Apply the second layer and allow to dry approx. 3 hours before applying the third thicker coat

 
Technical Data
Finish Satin
Waterbased Yes
03.Drying Time (Recoat) 12 hours
04.Drying Time (Full cure) 2 weeks
Smooth Coverage (m2 / litre) 8-10
Type Single Pack
Application Method Brush, Spreader
 
Product customization

We can tint this product to your exact specification from any colour chart or sample. If you know the reference please enter the code in the field below, click SAVE and add the product to your basket. We also have ideas to set the ball rolling in our Colour section where we have added a number of widely used colour ranges. Need help? Call us on 01793 511537

Enter your COLOUR REFERENCE in the box below:

loader

* required fields

11 other products in the same category:

Menu

Top
Compare 0