Tikkurila Anti Reflex 2 Ceiling Paint

Reference:
V30

Tikkurila Anti-Reflex White is a revolutionary anti-reflective paint for ceilings that provides a flat, uniform, blemish-free finish.

Hides and removes roller tramlines and brush marks. Only one coat may be needed for full opacity.

Colour: White

£17.43 (excl VAT)
£20.92 (incl VAT)
£17.43 (tax excl.)
Size
  • 3L
  • 10L
Close
Description

About Tikkurila Anti-Reflex White

Tikkurila Anti-Reflex White is a high opacity super white, anti-reflective, matt emulsion for painting indoor ceilings.

It removes light reflections that create the impression of unevenness in the surface and is ideal for ceilings in residential, office and public spaces- including schools and kindergartens, hospitals, production plants, also the food industry (without direct contact with food) *.

It emits a neutral odour during application and drying and is resistant to gentle washing.

Anti-reflective properties optically eliminate the imperfections on the surface.

It can be used for painting of previously painted surfaces, putty surfaces, plaster, fireboard, chipboard, plaster facing, fibreglass wall papers and concrete.

It is ideal choice for: living rooms, kids rooms, bedrooms, dining rooms, hotels, hallways and in offices and public areas. It

It is recommended for painting of large area and large lighting ceilings, creates fully matt and antireflex small-grained surface.

Provides a uniform flat matt finish regardless of the angle of incidence of light.

  • Provides a uniform flat matt finish regardless of the angle of incidence of light.
  • High opacity - only one coat may be needed
  • Eliminates streaks and stripes
  • Good open time
  • Excellent Flow and levelling
  • Low VOC content with a neutral odour
  • Does not spatter or drip

Application Conditions

All painted surfaces must be dry clean and free from any materials that would affect adhesion of paint to the surface. For best results apply in environments where the air temperature between 5 ° C and + 25 ° C, and relative air humidity below is 80%.

Unpainted surfaces covered with filler, plaster, concrete and chipboard, felt and gypsum boards:

Clean the surface of dust, dirt and loose materials. Repair and surface defects with a good quality interior filler. Prime with Tikkurila Anti-Reflex White diluted with water (up to a maximum of 20%)

Surfaces painted with dispersion, alkyd and oil paints;

Before painting the surface should be thoroughly washed and degreased. Lightly abrade glossy surfaces with medium-grain abrasive paper. Rinse thoroughly with water, dry.

Surfaces painted with lime paints;

Clean the surface of dust, dirt and loose materials. Repair and surface defects with a good quality interior filler formulated for lime plaster repairs. Prime with Tikkurila Anti-Reflex White diluted with water (up to a maximum of 20%).

Thinning

No thinning required, except for the primer coat.

Application

Tikkurila Anti Reflex can be applied by Brush, Roller or Spray

Coverage Rates

8 to 11 m2/L per coat. 

Coverage rates depend a lot on factors, such absorbability, substrate texture, application method etc.

Drying Time

Drying time at 23°C and 50% relative humidity, approximately 30 minutes.

Re-coat time is at least 3 hours.

Cleaning Tools

Tools should be cleaned with water immediately after finishing work.

The product contains less than 15g/Litre VOC.

For further information refer to the Product Data Sheet and Material Safety Data Sheet.

Features
V30
Drying Time - To Handle
30mins
Drying Time - Recoat
30mins
Coverage (m2 / litre)
10
Application
Brush, Roller, Spray
Single / Two Pack
Single
Water Based
Yes
FAQS

questions Greg
Question: 

The anti reflex 2 by tikkurila, can it be tinted? Thanks in advance

Answer: 

Hello,

The Anti-Reflex 2 is not tintable and only availible in white.

Holman Specialist Paints.


Question about the product

* Required fields
Send Question
All Colour Charts
Recently Viewed

Menu

Settings

Need help? Call 01793 511537