Protectapeel Multisurface is a water-based temporary peelable protective coating designed to protect internal non-porous surfaces from damage caused by; abrasion, staining, spillage and scratching. The liquid applied coating dries to form a tough film that will protect interior surfaces such as; plastics, acrylics, marble, work surfaces, stainless steel, concrete, lacquered flooring, tiles and paintwork for up to 12 months.
Colour - Grey. Also available pigmented in a colour upon request.
Use a wet film gauge to ensure that the minimum wet film thickness is achieved.
The contents of the container should be mixed thoroughly before use. Always conduct a test area and a test peel on each substrate before use.
A minimum wet film thickness (WFT) of 300 Microns (100 Microns dry film thickness - DFT) must be achieved, anything less may result in the product becoming difficult to remove.
Do not apply in wet or freezing conditions and protect from rainfall.
Apply with airless spray gun, using a 17 thou tip size to achieve a minimum WFT of 300 Microns (100 Microns DFT).
Apply using a Lambswool roller.
Apply 2 coats, allowing 1st to tack off.
Apply generously to achieve a minimum WFT of 300 Microns (100 Microns DFT).
Tack Free Drying Time
A WFT of 300 Microns will be tack free in approximately 140 minutes at room temperature.
Force drying may be used by using moving air and increasing the surface temperature to a maximum of 50°C.
The theoretical coverage rate is approximately 4m2 per kg at a WFT of 300 Microns.
The dry film can be easily removed either by hand peeling or by pressure hose.
Do not remove in freezing conditions as the coating may be brittle.
External Weather Resistance
Protectapeel Multisurface is suitable for Internal Use only up to 12 months exposure.
Clean rollers and equipment with water immediately after use.
If the protective coating rips, repair by lifting the ripped patch and apply a fresh coat to the underside and reseal. Alternatively, cut away the damaged area and apply a fresh coat.
Viscosity: 9000 ± 2000 cP @ 20°C
Flash Point: N/A
Density: 1.09 kgl -1
Tensile Strength: >5 MPa
Elongation: 1000 %
Adhesion: < 1.0 MPa
Solids Content: 32% ± 2 %
Maximum VOC: 0
Health & Safety Information
The compound is non-toxic and non-flammable in the wet state. The dry film waste may be disposed of as low hazard. For more information please refer to the Safety Data Sheet (SDS) for this product.
Shelf life 24 months in dry conditions.
Store at temperatures between 5°C - 25°C.
DO NOT ALLOW THE LIQUID TO FREEZE.