Polyvine Stone and Brick Protector

About Polyvine Stone and Brick Protector

A high performance water-based masonry protector and water repellent. Dries to a dead flat finish, which retains the natural look of the substrate. Protection of the surface begins immediately after application and is complete in approximately 24 hours.

Key Features

• Waterproofs brick and stone
• Suppresses formation of salts on natural masonry surfaces
• Improves weatherability
• A moisture barrier - seals off the surface
• Resists penetration of grease, oil, acids, alkaline, salts
• Easily cleaned with mild soap and water
• Suitable for interior and exterior use
• Chemical resistant
• Quick drying
• Microporous
• Nano technology
• Water wash up

Preparation

Do not use in temperatures below 5°c/40°f or in very high humidity. Stone and brick protector should be used as supplied, without dilution, by brush, spray or roller.

Application

Mix well before use. For general applications on masonry, brickwork and stone, a single application will be sufficient.

Drying Times and Coverage

Drying time: 15 minutes to 1 hour depending on temperature
Coverage: 15-20 square metres per litre, depending on the porosity of the material.

Caution

Always test on a trial area before application. Apply evenly and do not allow to pool in crevices. Test for clarity over dark colours.

NOTE: A chemical reaction could take place on some substrates such as glass, glazed surfaces, lead or aluminium. Mask these materials before application. In case of contact, rinse thoroughly with water immediately.

Storage

Store in unopened containers in a cool dry place away from direct sunlight. Protect from extremes of temperature during storage and application.

Health, safety and the environment

Non-hazardous. Ensure good ventilation.
Keep out of reach of children.
Contact with eyes - wash immediately with warm water.
Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty into drains or watercourses.