About Rust-Oleum Fillcoat Fibres Waterproofing System
The Rust-Oleum Fillcoat Fibres provide an instantly waterproof elastic coating. Suitable for roofs, non-walkable terraces, gutters, ridge-pieces, chimney stacks, pipes, etc. It has excellent resistance against temperature fluctuations, weathering and UV.
Fillcoat does not contain bituminous products and has excellent adhesion onto bituminous surfaces, hard PVC, polyester, zinc, aluminium, glass, tiles, etc
The Fillcoat Fibres system is used for bridging cracks up to 2 mm wide, small active cracks or repeatedly repaired spots.
For larger, important or active cracks see the Fillcoat system reinforced with the Dacfill Fleece
Properties of the Fillcoat Fibres
- Immediately watertight
- Good resistance to weather and acid rain
- Can be used in all weather conditions – except snow
- Excellent adhesion to a very wide range of substrates
- Easy to apply with a roller, brush, floor squeegee or spatula
- Can be over coated with protective coatings such as Dacfill, Noxyde®
- Elastic up to 1300%
Surface Preparation
Remove dust, mud, grease and any surface contamination.
The spots to be repaired should be cleaned with a hard broom and sponge.
Porous materials (concrete, stone, wood) must first be dried and pre-treated with a coat of Primer 44HS.
In case of repeatedly repaired spots, important or active cracks, apply Fillcoat Fibres crosswise over the cracks or fissures.
Application and Thinning
Brush, do not dilute.
Roller, do not dilute.
Air-atomised spray, not recommended.
Airless spray, not recommended.
