Current best sellers

Special Offers

Rust-Oleum Hardhat Topcoats

New product

Rust-Oleum Hardhat Topcoats are long lasting high gloss industrial aerosols, offering more hiding power - more coverage and a high film build without sags and drips.

More details

We can tint this product to your exact specification from any colour chart or sample. Enter your chosen colour in the box below and click CONFIRM COLOUR before adding the product to your basket. Need help? Call us on 01793 511537




- +

Product Info

Please note that due to the current Coronavirus situation, all Rust-Oleum products are subject to a 10 day lead time.

Rust-Oleum Hard Hat Aerosol Topcoats are high performance spray enamels. They are suitable for small maintenance jobs or for touch-up in light industrial exposures, normal humidity and interior applications.
Ideal for refurbishing agricultural equipment, machinery and pipe work.

High coverage rate
Longer lasting than most other spray enamels
Provides a higher film build for greater hiding power
Resists chipping, cracking and peeling
High gloss finish with excellent colour retention

Surface Preparation
Remove dirt, grease, oil, loose rust and all other surface contaminants using ND14 Cleaner Degreaser. Prime or spot prime with the recommended RUST-OLEUM Primer. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application.

Application and Thinning
Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use.
Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
Special note, Bright topcoats may need a light coloured primer/intermediate coat.


Technical Data
Coverage Smooth
Finish Gloss
Solvent Based Yes
01.Drying Time (Touch Dry) 15 minutes
02.Drying Time (To handle) 30 minutes
03.Drying Time (Recoat) less than 1 hour to more than 48 hours
04.Drying Time (Full cure) 1 Week
Smooth Coverage (m2 / litre) 3-4m2 per can
Type Single Pack
Flammable Yes
Application Method Aerosol
Product customization

We can tint this product to your exact specification from any colour chart or sample. If you know the reference please enter the code in the field below, click SAVE and add the product to your basket. We also have ideas to set the ball rolling in our Colour section where we have added a number of widely used colour ranges. Need help? Call us on 01793 511537

Enter your COLOUR REFERENCE in the box below:


* required fields

30 other products in the same category:


Compare 0