£11.33 (incl VAT)
Sikkens Cetol WP 566 High Performance Base Stain
A high performance penetrating translucent water-borne base stain in a range of colours
For Interior and Exterior use Specially formulated for application by dipping, flow coating and saturation spraying
Excellent run off properties
Reduced grain raising
Excellent absorption and adhesion to timber
Can be used over most fully dried preservative treated timber
Colours are available from the Sikkens Joinery Color Classics Collection.
£11.33 (incl VAT)
About Sikkens Cetol WP 566 High Performance Base Stain
Sikkens Cetol WP 566 replaces Cetol WP 560 high performance base stain and represents the very best in high quality, translucent, water-borne and moisture vapour permeable coatings.
It provides the perfect platform for Sikkens Finishes.
Colours are available from the Sikkens Joinery Color Classics Collection.
please note - medium to highly pigmented translucent colours are more weather-resistant than low pigmented colours.
Colourless coatings are not suitable for outdoor use.
On timber rich in extractives, e.g., oak, larch or tropical wood, discolouration may occur – partially only as a result of weathering
Processing
Apply by using dipping, flow-coating, brushing machine or vacuum coater
Processing viscosity is approximately 11 seconds in a DIN cup 4 mm or approx. 23 - 25 seconds in a ISO cup 3 mm at 20 °C material temperature
Consumption
50 - 160 ml/m², depending on application method, type and the absorption properties of wood (exact values must be established by tests).
Ready to use but can be thinned with water to a maximum of 5% by volume
Application temperature
15 - 25 °C for substrate, air and material at approx. 60 % R.H.
Drying times at 23°C / 50% RH
Dust dry, approximately 30 minutes
Sandable approximately 4 hours
Recoatable approximately 4 - 6 hours
The drying process of the coating depends on the applied film thickness and may be delayed when using timber with a high extractive contents or drying in
damp/cold conditions. During the drying process, always ensure for adequate temperature and ventilation.
If the drying conditions are not met, damages within the coating cannot be excluded.
Cleaning of equipment
Clean with water immediately after use with water or Sikkens ST 830 Cleaning Solution.
Disposal
Only empty containers may be recycled. Dispose of material residues according to local regulations. The EC waste code applicable to such material
is: 08 01 12