TeknosPro wall paints are high quality, waterborne paints for professional builders. The paints are solvent-free alkyd-reinforced acrylate dispersion paints for dry indoor spaces.
Available in three gloss levels, Full Matt (TeknosPro 5), Matt with low side sheen (TeknosPro 7) and Matt (TeknosPro 10).
All three paints have good wear resistance and tolerate being wiped. Teknospro 5 can lasts over 5,000 brushings.
The paints are ideal for use on interior walls and ceilings, e.g. in apartments and offices. Easy to apply and give a smooth, matt surface with attractive appearance. TeknosPro 5 and 10 can be applied to concrete, plaster, stopper, brick and to various building boards. They can also be used for repainting old alkyd and dispersion paint coats.
The products have been classified in Emission Classification of building materials to Group 1.
Clean new surfaces from dust and dirt. Wash previously painted surfaces with RENSA SUPER paint cleaner. Matt down hard or gloss surfaces by sanding and thereafter remove the dust.
Remove all of the old paint from the surfaces which have been painted with glue paint or lime wash. Spray filler ceilings, which are not waterproof, are recommended to be primed with solvent-borne primer e.g. FUTURA 3 Adhesion primer.
For smoothing of irregularities in the surface choose a suitable stopper. The dried stopper is sanded down and the dust removed. Priming Prime concrete, plaster, stopper, brick and building board surfaces with TEKNOSPRO POHJA OR TeknosPro 5. Steel surfaces need to be primed with an anticorrosive paint.
Before use stir the paint thoroughly. The paint is thinned with water when needed. Apply once or twice by brush, roller or spray. Suitable nozzle for airless spray is 0.017 - 0.021".
The surface to be painted has to be dry. During the application and drying period the temperature of the ambient air, the surface and the paint should be above +5°C and the relative air humidity below 80%. Good ventilation during the application and drying period quickens the drying process.
The final forming of the paint film takes about 4 weeks under normal circumstances and after that the ultimate durability and hardness is reached. Before this the painted surface must be treated with care.
The painted surface can be cleaned by wiping with a neutral (pH 6 - 8) detergent. For very dirty surfaces can also alkalescent (pH 8 - 10) detergents be used. Detergent and dirt are removed by wiping and/or rinsing the surface with clean water. Use a cleaning cloth, soft sponge or similar for cleaning. Avoid coarse brushing or heavy abrasion. Follow the dilution and other instructions of the detergent producer when using detergents.