Rust-Oleum Flexible Epoxy B95


Outstanding corrosion protection in heavy industrial or coastal areas with the advantage of an elastic paint.

£360.68 (excl VAT)
£432.81 (incl VAT)
£360.68 (tax excl.)
Colour choice
Please enter your required colour into the box below and click 'Save Colour Choice'.
  • 250 char. max

    Your Colour:

  • 10L

About Rust-Oleum Flexible Epoxy B95

Rust-Oleum B95-Flexible Epoxy System is based on two-component, modified epoxy resins and is practically solvent free.

It is formulated for application on concrete, masonry, and hand tool prepared, blasted, primed or galvanized steel.

It provides excellent corrosion resistance in severe industrial and coastal exposures, high humidity and moisture conditions.

  • Virtually solvent free
  • Hard wearing and impact proof
  • Outstanding corrosion protection in heavy industrial or coastal areas
  • Semi gloss finish
  • Ideal for airless spray application
  • Low odour

Surface Preparation

Remove grease, oil and all other surface contaminations with ND14 or high pressure (steam) cleaning.

Sand intact coatings to roughen the surface slightly.

Check compatibility, especially when applied on reversible coatings (such as chlorinated rubber) on a test-patch is strongly recommended.

The surface must be clean and dry during application.

Concrete and masonry: New concrete or masonry should cure and dry for at least 30 days before applying the coating system. Remove laitance, any loose or unsound concrete or deteriorated coatings. Smooth concrete should be roughened. Remove curing compounds.

Steel: Remove loose rust, mill scale and deteriorated coatings by hand or power tool cleaning. Large areas may be thoroughly blast-cleaned.

Application and Thinning

Brush: 10 to 15 vol.%; Thinner 160.Use natural bristles, long hair brushes.

Roller: 10 to 15 vol.%; Thinner 160.Use medium pile polyamide (perlon 16 - 20 mm.) rollers. Roller application requires 2 coats to achieve recommended dry film thickness.

Airless spray: 5 to 15 vol.%; Thinner 160. Pneumatic and electric airless equipment. Tip size: 0.015-0.025 inch. Fluid pressure: 250 - 300 bar.

Coverage (m2 / litre)
Brush, Roller, Spray
Single / Two Pack
Two Pack
Water Based

Be the first to ask a question about this product!

Question about the product

* Required fields
Send Question
All Colour Charts
Recently Viewed



Need help? Call 01793 511537