Current best sellers

Special Offers

Teknos Satu Sauna Bench Protection Finish

New product

Satu Sauna Protection Finish (Satu Laudesuoja) is for benches in the steam-room. It is a colourless and odourless protection containing paraffin oil for wooden surfaces.

 It forms a dirt and water repellent but breathable coat. This product emphasises the natural colour of the wood.

More details

£16.95

- +

Brand: Teknos

 
Product Info

Satu Sauna Protection Finish (Satu Laudesuoja) is for benches in the steam-room. It is a colourless and odourless protection containing paraffin oil for wooden surfaces.

 It forms a dirt and water repellent but breathable coat. This product emphasises the natural colour of the wood.

It is suitable for the treatment of benches in the steam-rooms of saunas, wooden kitchen table tops etc. It can also be used on untreated and previously oil treated wooden surfaces. This protection finish can also be used for treating wall and ceiling panels in steam-rooms.

 Surface Preparation

Clean new wooden surfaces from dust and dirt. Wash previously oiled surfaces with Rensa Sauna cleaner and rinse thoroughly with water. If the wooden surface has previously been varnished or treated with protection for sauna, the surface must be sanded bare.

Application

Before use stir the product thoroughly. Apply Satu Sauna Finish Protection with brush, sponge or clean cloth. Apply to a clean and dry wooden surface 1 to 3 times depending on the absorption properties of the surface. Wipe off excess oil 30 minutes after the application.

Application Conditions

The surface to be treated must be dry. During the application and drying period the temperature of the ambient air, the surface and the product shall be above +10 °C and the relative air humidity below 80%. Good ventilation during the application and drying period quickens the drying process.

Maintenance

The surface can be cleaned by wiping with a neutral (pH 6 - 8) detergent. Detergent and dirt are removed by wiping and/or rinsing the surface with clean water. Use a cleaning cloth, soft sponge or similar for cleaning. Avoid coarse brushing or heavy abrasion. Follow the dilution and other instructions of the detergent producer when using detergents.

 

 
Technical Data
Application Brush, sponge, or clean cloth
01.Drying Time (Touch Dry) 1 hour
03.Drying Time (Recoat) 2 hours
04.Drying Time (Full cure) Next day
Clean Up Clean the equipment immediately after use with warm water and detergent
Approvals and Certificates M1 classification

Accessories

30 other products in the same category:

Menu

Top
Compare 0