Current best sellers

Special Offers

Rust-Oleum Mathys Pegakote Epoxy Floor Paint

New product

A high performance satin gloss floor coating with high resistance to abrasion, oils and solvents - available in a number of standard colours and also tinted to any colour of your choice.

More details

We can tint this product to your exact specification from any colour chart or sample. Enter your chosen colour in the box below and click CONFIRM COLOUR before adding the product to your basket. Need help? Call us on 01793 511537




- +

Product Info

Please note that due to the current Coronavirus situation, all Rust-Oleum products are subject to a 10 day lead time.

A very hard and durable two pack interior floor coating to protect and refurbish all types of concrete and stone floors
Pegakote will provide the perfect finish for areas such as garages, warehouses, showrooms, corridors, indoor car parks, workshops, and it also can be used to protect wall surfaces.

Abrasion resistant
Available in over 15000 colours
It is solvent free, almost odourless and easy to clean.
Can be applied directly on most mineral substrates such as old concrete, tiles and glass etc.
Resistant to oil and solvents

Surface Preparation.
Concrete to be treated must be dry and at least four weeks old and free of any soft surface laitance and contaminants.
Previous coatings should ideally be removed by wire brushing or sanding. If this is impractical the surface should be thoroughly abraded and loose paint removed. All traces of grease or oil should be removed withND14 Cleaner Degreaser and the area thoroughly hosed off and allowed to dry.
Any curing compounds in the case of poly-concrete have to be removed by means of sand or grit blasting.
On new concrete or non-porous concrete, remove cement grout by sand or grit blasting, treatment with Surfa-Etch 108 or two pack High Adhesion Primer 3333.

Porous substrates should be treated with Pegakote diluted with 10 to 20% water.

Pegakote should not be applied to elastic paint coatings or surfaces prone to movement.

Application and Thinning
Brush: and if necessary, dilute with water.
Roller: Dilute 1st coat with a maximum of 10% water.

Apply 2nd coat undiluted.
Air-atomised spray: Not recommended.
Airless spray: Nozzle: 021 - 023 / Pressure: 220 bars.
1st coat: dilute with 5 - 10% water. 2nd coat: dilute with a maximum of 5% water.

Colour choice
Floors where heavy use and abrasion is expected, standard and medium colours are recommended. If deep or bright tones (red, yellow, orange, green, blue) are preferred it is recommended that a clear coat be applied

Technical Data
Coverage Smooth
Finish Satin
Waterbased Yes
01.Drying Time (Touch Dry) 9 hours
03.Drying Time (Recoat) 24 hours
04.Drying Time (Full cure) 1 Week
Coverage (kg/m2) 0.3-0.4
Type Two Pack
Application Method Brush, Roller, Spray
Product customization

We can tint this product to your exact specification from any colour chart or sample. If you know the reference please enter the code in the field below, click SAVE and add the product to your basket. We also have ideas to set the ball rolling in our Colour section where we have added a number of widely used colour ranges. Need help? Call us on 01793 511537

Enter your COLOUR REFERENCE in the box below:


* required fields


30 other products in the same category:


Compare 0