Rust-Oleum Epoxyshield Garage Kit

New product

Epoxy Shield Maxx Garage Floor Coating kit
Highly durable, easy to clean, and resists petrol, antifreeze, motor oil, salt and hot tire pick-up

More details

We can tint this product to your exact specification from any colour chart or sample. Enter your chosen colour in the box below and click CONFIRM COLOUR before adding the product to your basket. Need help? Call us on 01793 511537



Product Info

Please note that due to the current Coronavirus situation, all Rust-Oleum products are subject to a 10 day lead time.

Epoxyshield Garage Floor Coating can be applied on concrete floors, which are completely clean and dry. It can also be applied on sound previously painted floors.

2 Pack water based epoxy
Resists oil, petrol, anti freeze, salt and hot tyre pick up
Highly durable
Attractive decorative effect
Each kit covers 25m2 and comprises
Very easy to clean

Kit includes; 2-part Epoxy Floor Coating, Concentrated Cleaner, Decorative Chips, Stir stick, detailed instructions and a free Instructional DVD

The Epoxyshield Decorative Chips are specially designed for use in combination with Epoxyshield Garage Floor Coating. The chips adhere permanently on the floor when they are sprinkled in the wet coating. They give a decorative finish and will also mask dirt.

Surface Preparation
Repair any holes or cracks. If the floor is previously painted, remove any loose paint by sanding and scraping. Remove oil and grease using a scrubbing brush and ND14 cleaner degreaser. Rinse thoroughly with fresh water afterwards. Remove all water and allow to dry completely.

Mixing. Pour the contents of A into B and stir thoroughly for at least 3 minutes. Allow mixed product to stand (see table) before rolling the coating on to the surface. Do not leave container in direct sunlight. Mix again before applying.
The product must be used within 1 to 2 hours of initial mixing. This time decreases at higher temperatures.
Do not mix Paint Chips with Epoxyshield Garage floor coating

Application and Thinning
After the full 60 minutes use a paint roller (20 cm) to apply an even coat to the surface. Apply in sections of 1,5 x 1,5 m so that Epoxyshield Decorative Chips can easily be scattered on the freshly coated surface. Maintain a wet edge to prevent lap marks and gloss differences. Sprinkle the decorative paint chips onto the wet film (note: this step may be skipped if chips are not desired. This will not affect the performance of the coating). Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area). Only one coat is necessary.

It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent a good adhesion.

Technical Data
Coverage Smooth
Finish Gloss
Waterbased Yes
01.Drying Time (Touch Dry) 16 hours
02.Drying Time (To handle) 2 days
03.Drying Time (Recoat) 2 days
04.Drying Time (Full cure) 1 Week
Smooth Coverage (m2 / litre) 7
Type Two Pack
Application Method Brush, Roller
Product customization

We can tint this product to your exact specification from any colour chart or sample. If you know the reference please enter the code in the field below, click SAVE and add the product to your basket. We also have ideas to set the ball rolling in our Colour section where we have added a number of widely used colour ranges. Need help? Call us on 01793 511537

Enter your COLOUR REFERENCE in the box below:


* required fields


30 other products in the same category:


Compare 0