Rust-Oleum Non-Slip Floor Coating 7100NS

Please note that due to the current Coronavirus situation, all Rust-Oleum products are subject to a 10 day lead time.

Rust-Oleum 7100NS Floor Coating is a high quality, durable single pack coating for light to medium traffic areas.
It contains a special synthetic anti slip aggregate to increase safety whilst being easily cleaned. The coating has a good resistance against abrasion and neutral detergents (no alkaline cleaning agents) and is resistant to short contact periods against lubricating oils, fuel, petrol etc.

Single pack, solvent based
For foot traffic, interior and exterior
High Gloss finish that is easily cleaned
To apply to old concrete (older than 2 years) and metal
High film build in one coat
Touch dry after 6 hours
Easy to apply with brush and roller

Surface Preparation
Remove oil, grease and other contaminations with ND14 Cleaner Degreaser or with high pressure steam cleaning. Sand old intact coatings to roughen the surface in order to establish a good adhesion. Check the compatibility with old intact coatings.

During application the surface should be dry and clean.

On porous concrete a first coat should be applied with 7100 diluted with 10% 7301 Special Thinners. Remove curing compounds by means of dust free blasting.

Application and Thinning
Brush: Sparingly, if required, with 10% special thinners 7301.
Roller: Sparingly, if required, with 10% special thinners 7301.
In case of roller application it can be necessary to apply 2 coats in order to obtain the recommended film thickness.

Do not apply on alkaline substrates.

Important: Not Recommended for car traffic or for car park areas. For this application please use Rust-Oleum EpoxyShield