Current best sellers

Special Offers

Rust-Oleum Epoxyshield Maxx

New product

Rust-Oleum Epoxy Shield Maxx - Maximum durability in just one coat. A high performance floor coating for medum to heavy traffic. 

More details

We can tint this product to your exact specification from any colour chart or sample. Enter your chosen colour in the box below and click CONFIRM COLOUR before adding the product to your basket. Need help? Call us on 01793 511537




- +

Product Info

Please note that due to the current Coronavirus situation, all Rust-Oleum products are subject to a 10 day lead time.

Rust-Oleum Epoxyshield MAXX is an easy to apply water-based heavy duty epoxy floor coating with very high adhesion and durability. The product has an excellent wear, impact and abrasion resistance and resists chemicals and standing water. It can be used in combination with decorative chips or an anti slip additive.

Epoxyshield Decorative Chips are specially produced for use in combination with Epoxyshield MAXX. The chips adhere permanently on the floor when they are sprinkled in the wet coating.
They give a decorative finish and will also mask dirt.

For medium to heavy traffic
Easy to apply and no primer is necessary
Long lasting gloss finish
Excellent car tyre resistance
Highly resistant against solvents and chemicals
Non skid or decorative finish is optional
Apply to new, old and previously painted concrete

Surface Preparation
Repair any holes or cracks with Concrete Repair products. If the floor is previously painted, remove any loose paint by sanding and scraping. Remove oil and grease using a scrubbing brush and ND14 cleaner degreaser. Rinse thoroughly with fresh water afterwards. Allow to dry completely.

Application and Thinning
Pour the contents of A into B and stir thoroughly for at least 3 minutes. Allow mixed product to stand (see table) before rolling the coating on to the surface. Do not leave container in direct sunlight. Mix again before applying.
The product must be used within 1 to 2 hours of initial mixing. This time decreases at higher temperatures.
Do not mix Paint Chips with Epoxyshield MAXX.

After the full 60 minutes use a paint roller (20 cm) to apply an even coat to e surface. Apply in sections of 1,5 x 1,5 m so that Epoxyshield Decorative Chips can easily be scattered on the freshly coated surface. Maintain a wet edge to prevent lap marks and gloss differences. Sprinkle the decorative paint chips onto the wet film (note: this step may be skipped if chips are not desired. This will not affect the performance of the coating). Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area). Only one coat is necessary.

It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent adhesion

Technical Data
Coverage Smooth
Finish Gloss
Waterbased Yes
01.Drying Time (Touch Dry) 16 hours
02.Drying Time (To handle) 2 days
03.Drying Time (Recoat) 2 days
04.Drying Time (Full cure) 1 Week
Smooth Coverage (m2 / litre) 7
Type Two Pack
Application Method Brush, Roller

Epoxyshield Maxx

Health and Safety Data Sheet

Download PDF
Product customization

We can tint this product to your exact specification from any colour chart or sample. If you know the reference please enter the code in the field below, click SAVE and add the product to your basket. We also have ideas to set the ball rolling in our Colour section where we have added a number of widely used colour ranges. Need help? Call us on 01793 511537

Enter your COLOUR REFERENCE in the box below:


* required fields


30 other products in the same category:


Compare 0