Rust-Oleum 7200 Floorcoat PU

Reference:
R7200

Rust-Oleum 7200 Floorcoat PU is a tough single pack, polyurethane enhanced floor coating for use inside and out that offers good protection and is very easy to apply.

Available in Gloss and Satin finishes and is fully tintable in any colour from any colour card. 

Ideal for concrete floors, line marking, wooden floors and pre-painted floors

£51.22 (excl VAT)
£61.46 (incl VAT)
£51.22 (tax excl.)
Colour choice
Please enter your required colour into the box below and click 'Save Colour Choice'.
  • 250 char. max
Size
  • 5L
Finish
  • Satin
  • Gloss
Close
Description

About Rust-Oleum 7200 Floorcoat PU

Rust-Oleum 7200 Floorcoat PU is a single pack easy to apply solvent based urethane modified alkyd floor coating specially formulated for applying on dry concrete, wood and masonry.

For interior and exterior use.

Ideal as a line marking product,

Good resistance against abrasion and neutral detergents (no alkaline cleaning agents) and is resistant during short contact periods against lubricating oils, fuel, petrol etc.

It can be applied directly on concrete floors, wooden floors and masonry which are completely clean and dry.

It is not recommended to apply on smooth/dense concrete or concrete containing a damp repellent additive, which will prevent a good adhesion.

Can also be applied on old good adhering coatings and onto metal floors which have been correctly prepared and primed with a suitable Rust-Oleum metal primer.

Preparation 

Remove oil, grease and other contamination with Rust-Oleum Mathys ND14 Cleaner Degreaser or high pressure (steam) cleaning in combination with appropriate detergents.

Sand old intact coatings to roughen the surface in order to establish a good adhesion.

Check the compatibility with old intact coatings.

During application the surface should be dry and clean.

On porous concrete a first coat should be applied with Rust-Oleum 7200 Floorcoat PU diluted with ±5% Rust-Oleum Thinner 633.

On new concrete (>28 days old) use Rust-Oleum 7201 Universal Floor Primer as a first coat or use Rust-Oleum Mathys 108 Surfa Etch Solution to neutralise any remaining alkalinity from the cement.

Remove curing compounds by means of dust free blasting.

Application & Thinning:  

Thin if required with 5% Rust-Oleum Thinner 633.

In case of roller application it can be necessary to apply 2 coats in order to obtain the recommended film thickness.

Air-Atomised Spray: Thin with max. 10% Rust-Oleum Thinner 641.

Gravity cup and pressure cup. Tip size: 1.0 -1.5 mm. Atomising pressure: 2 – 4 bar.  

Apply in a dry and well-ventilated area.

Do not apply Rust-Oleum 7200 Floorcoat PU on alkaline substrates, or in areas which will be constantly under water.

Features
R7200
FAQS

Be the first to ask a question about this product!


Question about the product

* Required fields
Send Question
All Colour Charts
Recently Viewed
Floor Paints and Varnishes
£51.22 (excl VAT)
£61.46 (incl VAT)
£51.22 (tax excl.)
Rust-Oleum 7200 Floorcoat PU is a tough single pack, polyurethane enhanced floor coating for use inside and out that offers good protection and is very easy to apply. Available in Gloss and Satin finishes and is fully...

Menu

Settings

Need help? Call 01793 511537