About Rust-Oleum Non Slip S/B Floor Paint for Wood
Rust-Oleum Solvent Borne NS Floor Coating is a high quality, durable and non slip single pack coating for light to medium traffic areas.
It has a High Gloss finish. It contains a special synthetic anti slip aggregate to increase safety whilst being easily cleaned. Easy to apply non slip surface.
- Single pack, solvent based
- For foot traffic, interior and exterior
- High Gloss finish that is easily cleaned
- High film build in one coat
- Brush and roller application
- Touch dry after 6 hours
7100NS Floor Coating can be applied on new and previously coated wooden floors that are completely clean and dry.
Surface Preparation
Ensure that the surface is clean and free from wax, polish or other contaminants.
Thoroughly abrade to form a key using 120 grade sandpaper or wet and dry paper.
Remove dust by vacuuming and wipe over with a 'sharp' solvent and allow to dry.
Varnish in poor condition should be completely removed.
Test a small area first for coating adhesion and/or compatibility prior to treating the whole floor.
On porous timber floors thin the first coat with up to 10% thinners.
Application and Thinning
Brush: Sparingly, if required, with 10% special thinners 7301.
Roller: Sparingly, if required, with 10% special thinners 7301.
In case of roller application it can be necessary to apply 2 coats in order to obtain the recommended film thickness.
On oily or resinous timbers wipe the surface with a sharp solvent and allow to dry. Test a small patch for adhesion.
- Drying Time - Touch Dry
- 6hrs
- Drying Time - To Handle
- 24hrs
- Drying Time - Recoat
- 24hrs
- Drying Time - Full Cure
- 1 Week
- Coverage (m2 / litre)
- 8
- Application
- Brush, Roller
- Solvent Based
- Yes
Review this Product