Rust-Oleum Floor Paint 7100
Easy to apply solvent based Alkyd floor coating specially designed for applying on old (>2 years), dry concrete for interior and exterior use.
The coating has a good resistance against abrasion and neutral detergents (no alkaline cleaning agents) and is resistance during short contact periods against lubricating oils, fuel, petrol etc.
Top quality high gloss finish for old concrete and metal floors.
Single pack, solvent based floor coating
For foot traffic, interior and exterior
For old concrete floors (>2 yrs), metal and wood
High gloss appearance, great hiding power
Touch dry after 6 hours (at 20°C)
**Please note limited colours and quantities remain, the 7100 has been replaced by the 7200.
New product can be found through link below:
About Rust-Oleum Floor Paint 7100
Rust-Oleum 7100 Floor Coating is a high quality, durable, single pack coating for light to medium traffic areas.
It has a High Gloss finish that is easily cleaned.
The coating has a good resistance against abrasion and neutral detergents (no alkaline cleaning agents) and is resistant to short contact periods against lubricating oils, fuel, petrol etc.
- Single pack, solvent based
- For foot traffic, interior and exterior
- To apply to old concrete, older than 2 years and metal
- High film build in one coat
- Touch dry after 6 hours
- Easy to apply with brush and roller
Surface Preparation
Remove oil, grease and other contaminations with ND14 Cleaner Degreaser or with high pressure steam cleaning.
Sand old, intact coatings to roughen the surface in order to establish a good adhesion.
Check the compatibility with old intact coatings.
During application the surface should be dry and clean.
On porous concrete a first coat should be applied with 7100 diluted with 10% 7301 Special Thinners.
Remove curing compounds by means of dust free blasting.
Application and Thinning
Brush: Sparingly, if required, with 10% special thinners 7301.
Roller: Sparingly, if required, with 10% special thinners 7301.
In case of roller application, it can be necessary to apply 2 coats in order to obtain the recommended film thickness.
Do not apply on alkaline substrates.
Important: Not Recommended for car traffic or for car park areas. For this application use Rust-Oleum EpoxyShield
- Drying Time - Touch Dry
- 6hrs
- Drying Time - To Handle
- 24hrs
- Drying Time - Recoat
- 24hrs
- Drying Time - Full Cure
- 1 Week
- Coverage (m2 / litre)
- 8
- Application
- Brush, Roller
- Single / Two Pack
- Single
- Solvent Based
- Yes