£96.55 (incl VAT)
Rust-Oleum Epoxy Shield Maxx - Maximum durability in just one coat. A high performance floor coating for medum to heavy traffic.
£96.55 (incl VAT)
About Rust-Oleum Epoxyshield Maxx
Rust-Oleum Epoxyshield MAXX is an easy to apply water-based heavy duty epoxy floor coating with very high adhesion and durability. The product has an excellent wear, impact and abrasion resistance and resists chemicals and standing water.
It can be used in combination with decorative chips or an anti-slip additive. Epoxyshield Decorative Chips are specially produced for use in combination with Epoxyshield MAXX. The chips adhere permanently on the floor when they are sprinkled in the wet coating. They give a decorative finish and will also mask dirt.
- For medium to heavy traffic
- Easy to apply and no primer is necessary
- Long lasting gloss finish
- Excellent car tyre resistance
- Highly resistant against solvents and chemicals
- Non skid or decorative finish is optional
- Apply to new, old and previously painted concrete
Surface Preparation
Repair any holes or cracks with Concrete Repair products.
If the floor is previously painted, remove any loose paint by sanding and scraping.
Remove oil and grease using a scrubbing brush and ND14 cleaner degreaser.
Rinse thoroughly with fresh water afterwards.
Allow to dry completely.
Application and Thinning
Pour the contents of A into B and stir thoroughly for at least 3 minutes.
Allow mixed product to stand (see table) before rolling the coating on to the surface.
Do not leave container in direct sunlight. Mix again before applying.
The product must be used within 1 to 2 hours of initial mixing.
This time decreases at higher temperatures.
Do not mix Paint Chips with Epoxyshield MAXX.
After the full 60 minutes use a paint roller (20 cm) to apply an even coat to the surface.
Apply in sections of 1,5 x 1,5 m so that Epoxyshield Decorative Chips can easily be scattered on the freshly coated surface.
Maintain a wet edge to prevent lap marks and gloss differences.
Sprinkle the decorative paint chips onto the wet film (note: this step may be skipped if chips are not desired. This will not affect the performance of the coating).
Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area).
Only one coat is necessary.
It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent adhesion
- Drying Time - Touch Dry
- 16hrs
- Drying Time - To Handle
- 2 Days
- Drying Time - Recoat
- 2 Days
- Drying Time - Full Cure
- 1 Week
- Coverage (m2 / litre)
- 7
- Application
- Brush, Roller
- Single / Two Pack
- Two Pack
- Finish
- Gloss
Review this Product