Rust-Oleum Epoxyshield Garage Kit

Brand:
Reference:
REPOXYGAR

Epoxy Shield Maxx Garage Floor Coating Kit Highly durable, easy to clean, and resists petrol, antifreeze, motor oil, salt and hot tire pick-up.

£73.40
£73.40 (excl VAT)
Colour choice
Please enter your required colour into the box below and click 'Save Colour Choice'.
  • 250 char. max
Colour
  • Grey
Description

About Rust-Oleum Epoxyshield Garage Kit

Epoxyshield Garage Floor Coating can be applied on concrete floors, which are completely clean and dry. It can also be applied on sound previously painted floors.

  • 2 Pack water based epoxy
  • Resists oil, petrol, anti freeze, salt and hot tyre pick up
  • Highly durable
  • Attractive decorative effect
  • Each kit covers 25m2
  • Very easy to clean

Kit includes;

  • 2-part Epoxy Floor Coating
  • Concentrated Cleaner
  • Decorative Chips
  • Stir stick
  • Detailed instructions and a free Instructional DVD

The Epoxyshield Decorative Chips are specially designed for use in combination with Epoxyshield Garage Floor Coating. The chips adhere permanently on the floor when they are sprinkled in the wet coating. They give a decorative finish and will also mask dirt.

Surface Preparation

Repair any holes or cracks. If the floor is previously painted, remove any loose paint by sanding and scraping. Remove oil and grease using a scrubbing brush and ND14 cleaner degreaser. Rinse thoroughly with fresh water afterwards. Remove all water and allow to dry completely.

Mixing

Pour the contents of A into B and stir thoroughly for at least 3 minutes. Allow mixed product to stand (see table) before rolling the coating on to the surface. Do not leave container in direct sunlight. Mix again before applying. The product must be used within 1 to 2 hours of initial mixing. This time decreases at higher temperatures. Do not mix Paint Chips with Epoxyshield Garage floor coating.

Application and Thinning

After the full 60 minutes use a paint roller (20 cm) to apply an even coat to the surface. Apply in sections of 1,5 x 1,5 m so that Epoxyshield Decorative Chips can easily be scattered on the freshly coated surface. Maintain a wet edge to prevent lap marks and gloss differences. Sprinkle the decorative paint chips onto the wet film (note: this step may be skipped if chips are not desired. This will not affect the performance of the coating). Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area). Only one coat is necessary. It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent a good adhesion.

Features
REPOXYGAR
Drying Time - Touch Dry
16hrs
Drying Time - To Handle
2 Days
Drying Time - Recoat
2 Days
Drying Time - Full Cure
1 Week
Coverage (m2 / litre)
7
Application
Brush, Roller
Single / Two Pack
Two Pack
Finish
Gloss
Water Based
Yes
Reviews
No comments

Review this Product

  • Product Rating:
Colour Charts
FAQS

Be the first to ask a question about this product!


Question about the product

* Required fields
Send Question
Recently Viewed

Menu

Settings