About Sikkens Cetol WF 9810-46-25 Semi-Transparent, Satin-Matt Woodfinish

Cetol WF 9810 is a high performance waterborne, translucent, satin matt base, mid and finish coat for wooden components and constructions.

It is used as a one pot, three coat system for renovation and correction of old paint systems, inside and out.

• High transparency
• Good weather resistance
• Good UV protection
• Tested according to DIN EN 71 Part 3 "Safety of toys
• Specially formulated for application by brush
• Virtually eliminates blocking
• Quicker hard drying
• Improved impact resistance
• Excellent flexibility 
• Excellent weather resistance
• Excellent adhesion to suitably base stained timber 
• Moisture vapour permeable
• Superb bright translucency  

Preparation and Application

The wood moisture content should be between 12 % and 15 %.

The selected wood, the design and the applied layer thicknesses should comply with current technical standards for example, all horizontal surfaces should be bevelled by  15 ° and all edges shall be rounded with a radius of at least 2 mm.

Old and loose coatings must be completely removed. Intact coating should be completely sanded smooth.

Fresh wood must be impregnated prior to coating, if necessary.

Open joints and cracks should be repaired using with Kodrin WV Joint Sealing Compound.

The substrates must be dry, free from dust and grease.

The selection and application of the coating, especially the colour shade, is important too. Dark coatings in the exterior may lead to an elevated surface temperature (up to 80 °C) in direct sunlight.

Cleaning  

Clean equipment immediately after use with clean cold water or by a solution of Sikkens ST 830 and fresh lukewarm water.

Note

Timbers which contain extractives i.e Oak, Larch or tropical woods can cause discolouring - these can appear after weathering.