£20.42 (incl VAT)
Tikkurila Valtti Extra A very durable semi-transparent gloss wood finish. Valtti Color Extra enhances the natural beauty of wood whilst offering good water repellency, flexibility, durability and protection against the effects of moisture and UV-light. Solvent based exterior wood stain for brush or spray application.
Can be tinted to a range of semi-transparent shades.
£20.42 (incl VAT)
About Tikkurila Color Extra
Tikkurila Valtti Extra Semi-transparent gloss wood finish for use on exterior wood. Available in many attractive semi-transparent colours. Valtti Extra enhances the natural beauty of wood whilst offering good water repellency, flexibility, durability and protection against the effects of moisture, UV-light, and microbial growth.
Great for coating:
- Timber cladding
- Weather-boarding
- Doors
- Windows
- Facias
- Fencing
- Sheds
- Garden furniture, etc.
Can be tinted to any semi-transparent colour.
Surface Preparation
Surfaces must be clean, dry, and free from grease, dirt, oil, wax, loose material and surface contamination.
Use Tikkurila Mould Removal Solution and Cleaning Solution.
Fill cracks, joints, nail holes, with a good quality wood filler.
Ensure that existing glossy, previously stained and filled surfaces are thoroughly sanded to ensure adequate penetration into the surface of the wood.
Make sure that timber cladding, weatherboarding and timber glazing beads, etc., are adequately fastened with non-corrosive fixings.
Good quality non-setting glazing compounds which form a protective skin should be used in accordance with manufacturer’s instructions.
Particular attention with regards to preparation should be given to wood such as Oak, Teak, Cedar, Douglas Fir, Mahogany and Idigbo, which contain oil and water-soluble tannin which may impair the drying, hardening or adhesion and possible staining of surface coatings.
When coating new woodwork it is recommended that a priming coat of Valtti Base should be applied to all exterior wood which has not been pre-treated or vacuum impregnated with an approved wood preservative.
Apply liberally on end-grain.
Valtti Color Extra is not recommended for use with linseed oil putty.
Application and Thinning
Methods: brush or spray.For airless spray: use a 0.009” – 0.013” (0.23 – 0.33mm) spray tip.
Thinning: Valtti Extra requires no thinning. All surfaces to be painted must be dry, the moisture content of the wood below 20%, the temperature of the air at least +50C, and the relative humidity of the air below 80%.
- Coverage (m2 / litre)
- 8-10
- Application
- Brush, Spray
- Single / Two Pack
- Single
- Finish
- Gloss
- Solvent Based
- Yes
Review this Product