About Tikkurila Mould Removal Solution
Mould Removal Solution is used for the removal of mould and algae from both previously painted and unpainted surfaces. Mould Removal can also be used on surfaces discoloured with blue-stain before finishing treatment.
Surfaces must be clean, dry, and free from grease, dirt, oil, wax, rust, loose material and surface contamination. Use Tikkurila products for cleaning. Repair surface defects holes and cracks with a good quality repair filler.
Apply by sponge, brush or low-pressure garden spray. Mix Mould Removal Solution with water in the ratio of one part Mould Removal Solution to four parts water. To avoid possible streaks apply the mixture working from the bottom to the top of the area to be treated. Allow at least 1/2 an hour for the solution to react against the mould affected areas.
For badly moulded surfaces apply the mixture wet-on-wet until the mould disappears.
After treatment, wash down all surfaces with clean water and allow to dry thoroughly.
Note: When using Mould Removal Solution wear appropriate safety clothing i.e. gloves and eye protection in case of splashing.
Health and Safety
Contains: Sodium Hypochlorite, Sodium Hydroxide. Causes burns. Irritating to eyes and skin.
Warning! Do not use with other products as the combination may release dangerous gases (chlorine).