Top sellers

Protectapeel Glasstrip Original

New product

Protectapeel Glasstrip Original is a waterbased, weather resistant peelable protective coating for protecting glass and virtually all non-porous surfaces.

Colour,  Transparent blue as standard, to allow light to pass through. Can be made opaque upon request.

More details


- +

Product Info

Protectapeel Glasstrip Original is a waterbased, weather resistant peelable protective coating for protecting glass and virtually all non-porous surfaces internally and externally for up to 6 months including PVCu, painted surfaces, aluminium and other metals. It protects against damage such as scratches, surface abrasions, spillages, overspray, dust and dirt transfer, eliminating time delays, unnecessary waste, costly repairs and replacement.


 Glasstrip Original


Use a wet film gauge to ensure that the minimum wet film thickness is achieved.

The contents of the container should be mixed thoroughly before use. Always conduct a test area and a test peel on each substrate before use.

A minimum wet film thickness (WFT) of 300 Microns (100 Microns dry film thickness - DFT) must be achieved, anything less may result in the product becoming difficult to remove.

Do not apply in wet or freezing conditions and protect from rainfall.

Spray Application

Apply with airless spray gun, using a 17 thou tip size to achieve a minimum WFT of 300 Microns (100 Microns DFT). To avoid “feather edges”, apply masking tape before the product is applied. Paint up to and over the masking tape edge then remove tape when product is still wet to leave a defined edge.

Roller application

Apply using a Lambswool roller.

Apply 2 coats, allowing 1st to tack off.

Apply generously to achieve a minimum WFT of 300 Microns (100 Microns DFT).

Tack Free Drying Time

A WFT of 300 Microns will be tack free in approximately 120 minutes at room temperature.

Force drying may be used by using moving air and increasing the surface temperature to a maximum of 50°C.

Coverage Rate

The theoretical coverage rate is approximately 4m2 per kg at a WFT of 300 Microns.

Film Removal

The dry film can be easily removed either by hand peeling or by pressure hose.

Do not remove in freezing conditions as the coating may be brittle.

External Weather Resistance

Protectapeel Glasstrip Original is suitable for up to 9 months exposure.

Equipment Cleaning

Clean rollers and equipment with water immediately after use.


If the protective coating rips, repair by lifting the ripped patch and apply a fresh coat to the underside and reseal. Alternatively, cut away the damaged area and apply a fresh coat.

Technical Data

Viscosity: 18000 ± 2000 cP @ 20°C

Flash Point: N/A

Density: 1.09 kgl -1

Tensile Strength: >5 MPa

Elongation: >1000 %

Adhesion: < 1.0 MPa

Solids Content: 45% ± 2 %

pH: 7-8

Maximum VOC: 80 gl-1

Health & Safety Information

The compound is non-toxic and non-flammable in the wet state. The dry film waste may be disposed of as low hazard. For more information please refer to the Safety Data Sheet (SDS) for this product.


Shelf life 24 months in dry conditions.

Store at temperatures between 5°C - 25°C.


See the amazing results of Protectapeel Glass Strip here:

Technical Data
Coverage 4m2 per KG
Finish Semi-Transparent
Application Roller or Spray
Waterbased Yes
01.Drying Time (Touch Dry) 2 1/2 hours
Clean Up Water

Application Guide

Application Guide for Protectapeel Products

Download PDF


30 other products in the same category:


Compare 0